// Step 1 - Blink the status LED on D10
// Checks that the XIAO, the LED and R1 are soldered correctly.

const int LED_PIN = D10;   // our LED is wired to pin D10

void setup() {
  pinMode(LED_PIN, OUTPUT);       // D10 will send current out
  Serial.begin(115200);           // open a message channel to the computer
  Serial.println("Victor's Boat PCB is alive!");
}

void loop() {
  digitalWrite(LED_PIN, HIGH);    // LED on
  Serial.println("LED on");
  delay(500);                     // wait 0.5 seconds
  digitalWrite(LED_PIN, LOW);     // LED off
  Serial.println("LED off");
  delay(500);
}